system_rev comes from u-boot and is a constant 0x20, so
Bx boards also fall in this 'if' and will get setup with the
wrong gpio_wp pin. Switch to using the Beagle revision routine
to correcly set pin 23 only for C1/2/3 and C4 Boards. Bx boards
will then use the correct default pin setting.

Signed-off-by: Robert Nelson <robertcnelson@gmail.com>
---
arch/arm/mach-omap2/board-omap3beagle.c | 3 ++-
1 files changed, 2 insertions(+), 1 deletions(-)

diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c
index 623c352..75674c6 100644
--- a/arch/arm/mach-omap2/board-omap3beagle.c
+++ b/arch/arm/mach-omap2/board-omap3beagle.c
@@ -282,7 +282,8 @@ static struct gpio_led gpio_leds[];
static int beagle_twl_gpio_setup(struct device *dev,
unsigned gpio, unsigned ngpio)
{
- if (system_rev >= 0x20 && system_rev <= 0x34301000) {
+ if ((omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_C1_3) ||
+ (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_C4)) {
omap_mux_init_gpio(23, OMAP_PIN_INPUT);
mmc[0].gpio_wp = 23;
} else {
--
1.7.0.4

--
kernel-team mailing list
kernel-team@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/kernel-team