Hello,

I am getting a

SIOCSIFMTU: Invalid argument [ok]

message when re/starting eth0. I am wondering about that. The router's
MTU is set at 1500. Looking at the /etc/init.d/net.eth0 it seems the
inteface metrics should be calculated automatically.

Any ideas about where to look for the reason for the message? Additional
info below.

Thanks,

--
Valmor


-> /etc/init.d/net.eth0 restart
* Caching service dependencies ...[ ok ]
* Unmounting network filesystems ...[ ok ]
* Stopping eth0
* Bringing down eth0
* Stopping dhcpcd on eth0 ...[ ok ]
* Shutting down eth0 ... [ ok ]
* Starting eth0
* Bringing up eth0
* dhcp
* Running dhcpcd ...
eth0: dhcpcd 4.0.15 starting
eth0: waiting for carrier
eth0: carrier acquired
eth0: broadcasting for a lease
eth0: offered 192.168.0.200 from 192.168.0.1
eth0: acknowledged 192.168.0.200 from 192.168.0.1
eth0: checking 192.168.0.200 is available on attached networks
dnseth0: leased 192.168.0.200 for 259200 seconds
SIOCSIFMTU: Invalid argument [ ok ]
* eth0 received address 192.168.0.200/24
* Mounting network filesystems ...[ ok ]

-> cat /proc/net/route
Iface Destination Gateway Flags RefCnt Use Metric
Mask MTU Window IRTT

eth0 0000A8C0 00000000 0001 0 0 0
00FFFFFF 0 0 0

lo 0000007F 00000000 0001 0 0 0
000000FF 0 0 0

eth0 00000000 0100A8C0 0003 0 0 0
00000000 0 0 0