World IPv6 Day Problems
On Wed, Jun 08, 2011 at 09:42:22AM -0600, Trever L. Adams wrote:
> On 06/08/2011 09:32 AM, Tom Hughes wrote:
> > Works fine for my VMs with bridged networking - they see the radvd on
> > the network and configure an address.
> > Tom
> Would you care to share some documentation of some kind?
> <forward mode='route'/>
> <bridge name='virbr0' stp='off' delay='0' />
> <ip address='10.0.1.1' netmask='255.255.255.0'>
> <ip family='ipv6' address='fd00:xxxx:xxxx:1::1' prefix='64'>
> <ip family='ipv6' address='2001:xxxx:xxxx:0::1' prefix='64'>
> That didn't automatically add any of the ipv6 addresses. As I said, no
> radvd. If I read the bug reports correctly, it is supposed to be automagic.
Yes, when you add that <ip family='ipv6'> line and then
restart the network (virsh net-destroy TheCommons && virsh net-create TheCommons)
it should have started radvd automatically. The guest should then have automatically
got an address from radvd. This all works fine in my testing.
> Also, the systctl stuff mentioned in the bugs reports I mentioned were
> set to not allow ipv6, etc. Did you override these defaults somewhere?
That other bug is irrelevant, refering to much older libvirt prior to the
introduction of IPv6 support.
|: http://berrange.com -o- http://www.flickr.com/photos/dberrange/ :|
|: http://libvirt.org -o- http://virt-manager.org :|
|: http://autobuild.org -o- http://search.cpan.org/~danberr/ :|
|: http://entangle-photo.org -o- http://live.gnome.org/gtk-vnc :|
devel mailing list