I only recently discovered Crux, while looking for a small distro to use as the basis of a virtual appliance. *I downloaded the ISO, created a VM, and followed the directions in the handbook to install. *For some crazy reason, I decided to give JFS a try as my root file system. *Unfortunately, my disk won't boot. *I can boot from the ISO and mount the disk just fine, but the VM's Phoenix BIOS skips over the disk and goes straight to PXE.



Here's my lilo.conf:## /etc/lilo.conf: lilo(8) configuration, see lilo.conf(5)#
lba32install=text

boot=/dev/sdaimage=/boot/vmlinuz* * * * label=CRUX* * * * root=/dev/sda1* * * * read-only* * * * append="quiet"
# End of file



Here's my fstab:## /etc/fstab: static file system information## <file system> * * * *<dir> * * <type> * *<options> * * * * * * *<dump> <pass>


/dev/sda1 * * * * * * */ * * * * jfs * * * defaults * * * * * * * 1 * * *1#/dev/#SWAP# * * * * * swap * * *swap * * *defaults * * * * * * * 0 * * *0#/dev/cdrom * * * * * */cdrom * *iso9660 * ro,user,noauto,unhide *0 * * *0

#/dev/dvd * * * * * * */dvd * * *udf * * * ro,user,noauto,unhide *0 * * *0#/dev/floppy/0 * * * * /floppy * vfat * * *user,noauto,unhide * * 0 * * *0devpts * * * * * * * * /dev/pts *devpts * *defaults * * * * * * * 0 * * *0

none * * * * * * * * * /sys * * *sysfs * * defaults * * * * * * * 0 * * *0none * * * * * * * * * /proc * * proc * * *defaults * * * * * * * 0 * * *0#tmp * * * * * * * * * /tmp * * *tmpfs * * defaults * * * * * * * 0 * * *0

#shm * * * * * * * * * /dev/shm *tmpfs * * defaults * * * * * * * 0 * * *0#usb * * * * * * * * * /proc/bus/usb usbfs defaults * * * * * * * 0 * * *0
# End of file



_______________________________________________
CRUX mailing list
CRUX@lists.crux.nu
http://lists.crux.nu/mailman/listinfo/crux