2010/1/28 Pasi Kärkkäinen <firstname.lastname@example.org>:
> On Wed, Jan 27, 2010 at 07:21:54PM -0300, Sergio Belkin wrote:
>> Hi, I use Centos 5.4 x86_64
>> kernel used is 2.6.18-164.11.1.el5xen
>> I have a physical machine running Debian Etch (32 bit) and Debian
>> Lenny and I virtualized the first one as follows:
>> *Created a HVM DomU with Virt-Manager with a virtual disk file of 40000 M
>> *Boot from LiveCD, and created a swap and a ext3 partitions (Yes, very
>> simple layout).
>> *Rsync'd files from root partition of physical machine to partition
>> mounted on LiveCD on DomU.
>> *Chrooted and edited files /boot/grub/menu.lst, /etc/fstab, etc/mtab,
>> *Then I rebooted from hard disk and stay freezed with the message
>> "booting from hard disk" . But it doesn't boot at all from hard disk.
>> I can boot using grub-rescue-cdrom, but if I try to install grub with
>> grub-install it outputs:
>> "The file /boot/grub/stage1 not read correctly"
>> (I've tried --recheck option, and depmod and update-grub commands with
>> no success)
> Well.. stage1 is definitely needed by grub. So grub didn't get installed.
> Your domU can't boot then.
> - Do you have the stage1 file there?
> - Was the partition layout the same for the old server?
> - Is the grub.conf "root (hd0,X)" correct for the new disk?
> You can install grub from grub-shell like this, after chrooting to the filesystem:
> # grub
> device (hd0) /dev/sda
> root (hd0,0)
> setup (hd0)
> replace "hd0,0" with the correct partition index.
I've tried that, If that was the problem, I hadn't asked help to the list
I've found that it was a misunderstanding between Grub and the
filesystem. Target filesystem has inodes of 256 bytes while debian
etch version can read inodes of 128 bytes.
>> Open Kairos http://www.sergiobelkin.com
>> Watch More TV http://sebelk.blogspot.com
>> Sergio Belkin -
>> CentOS mailing list
> CentOS mailing list
Open Kairos http://www.sergiobelkin.com
Watch More TV http://sebelk.blogspot.com
Sergio Belkin -
CentOS mailing list